
ENGLISH 9
Daily use
Warning! Refer to Safety
chapters.
Burner overview
1
Burner cap
2
Burner crown
3
Ignition candle
4
Injector
5
Thermocouple
Ignition of the burner
Always ignite the burner before
positioning pots or pans
Warning! Be very careful when
you use open fire in the kitchen
environment. The manufacturer
declines any responsibility in
case of the flame misuse.
To ignite the burner:
1
. Push the electric ignition button witch is
marked by a little spark
, at the same
time turn the relevant control knob
anticlockwise to maximum position
.
2
. Release the spark generator button
when burner lights but keep the control
knob on this position for equal or less
than 10 seconds; this will let
thermocouple to warm up. If not, the gas
supply will be interrupted.
3
. After the flame is regular, adjust it as
preferred.
If after a few attempts the burner
does not ignite, check that the
crown and its cap are in correct
positions.
Warning! Do not keep control
knob pressed for more than 15
seconds. If the burner does not
light after 15 seconds, release
the control knob, turn it into off
position and wait for at least 1
minute before trying to light the
burner again.
In the absence of electricity you
can ignite the burner without
electrical device; in this case
approach the burner with a
flame, push the relevant knob
down and turn it counter-
clockwise to maximum gas
release position.
Warning! Maintain extreme
caution while operating with
open fire in kitchen environment.
Manufacturer declines any
responsibility in case of misuse of
flame.
If the burner accidentally goes
out, turn the control knob to the
off position and wait for at least
1 minute before trying to light it
again.
Kommentare zu diesen Handbüchern